Main purpose: flue gas desulfurization equipment, a variety of chemical equipment. Brushing Method: scraper, trowel smear. Characters: --------------------- white color, translucent or green, blue: easy to control the thickness of the construction, coated to prevent leakage. Flake mortar has excellent corrosion resistance, which is mainly concerned with the mastic composition. In general, anti-corrosion layer of corrosion failures are mainly a resin substrate by etching, the base resin is first generated weight loss, color change, etc., after the material causing bubbling, delamination, peeling or cracking, etc., leading to failure of the anti-corrosion layer , especially the latter, due to factors such as penetration, accelerated corrosive chemical medium is infiltrated into the inside of the protective layer. Therefore, the choice has good corrosion resistance of the resin matrix, it should also take effective measures to weaken, slow penetration of corrosive media or water vapor. The flake mortar than the matrix resin can provide more effective corrosion resistance, mainly because of the glass flakes can effectively prevent corrosion of the physical media or water vapor permeation. Flake has strong anti-permeability clay is related to its material composition, under normal circumstances, scaly clay tablets containing 10% -40% diameter ranging from glass flakes, clay, after construction is completed, the flat glass flake resin continuous phase was parallel overlapping arrangement to form a dense barrier layer structure. Corrosive media in the cured cement after penetration must undergo countless tortuous pathway, so corrosion-resistant layer of a certain thickness, the corrosion penetration distance greatly extended, corresponds to an effective increase in the thickness of the corrosion layer on the objective. Meanwhile, in the absence of glass flake reinforced, the resin matrix continuous phase there will be a lot of so-called "defects" such as pores, bubbles and other micro-joints, etc. The presence of these defects will accelerate the corrosion process or accelerate penetration of the medium, because once medium penetrate into these defects, the rate of penetration is improved at the same time, the area of ??contact with corrosive media matrix continuous phase also will be increased,